Hardie Panel Siding Installation Instructions

Hardiewrap weather barriers.

Hardie panel siding installation instructions.

And canada who are available to work with any contractor or builder. Install hardiplank siding with joints butted in moderate contact. Also by james hardie. Drive the nails to be just flush with the surface of the panel but not so deep that the nails dimple the panel surface.

We have dozens of installation specialists throughout the u s. As a homeowner you will work with a contractor who will facilitate the installation of your james hardie siding trim soffit wrap and flashing products including products with colorplus technology. Hardiebacker cement boards. Hardiepanel vertical siding must be joined on stud.

This document is intended for use by builders cladding installers and other contractors who may be involved with the installation of the reveal panel system. Install tech. 50mm away from corners. And canada who are available to work with any contractor or builder.

We have dozens of installation specialists throughout the u s. Eliminate the guesswork in creating this look with the reveal panel system with all parts including panels trims and fasteners supplied by james hardie. Place all nails 3 8 inch from the hardiepanel edge and at least 2 inches from any corner. Installation manual for reveal panel system page 3 section 1 introduction the material contained herein provides installation guidelines for the reveal panel system by james hardie.

Fasten the panels to the sub structure with a pneumatic nailer and corrosion resistant nails. Aspyre by james hardie. Hardiepanel vertical siding. Hardieplank lap siding.

Install tech docs. Re siding your house with hardiepanel vertical siding or combining it with hardieplank lap siding is sure to add visual punch to your design. Also by james hardie. 9 5mm from panel edges and no closer than 2 in.

As a homeowner you will work with a contractor who will facilitate the installation of your james hardie siding trim soffit wrap and flashing products including products with colorplus technology. 50mm away from corners plate keep nails 3 8 in. Figure 1 moderate contact keep fasteners 2 in. Beginning with a commercial grade panel developed for multi family and light commercial applications the reveal panel system by james hardie is a complete solution for creating a panelized look.

The first course of any wall should be installed over a 1 4 lath strip to ensure a consistent plank angle see figure 1. Optionally install the lap siding with a maximum 1 8 gap and caulk the joint see detail at right.