Your happijac experience is important to us.
Happy jack bed lift problems.
Bed lift the brake must be released and the motor unplugged.
Apply downward pressure to the bed platform.
If not exercise extreme caution during the following steps to avoid damage to the system.
Happijac bed lift leg support bracket installation.
Release the brake 3.
All down press and hold button 5 and all 4 jacks retract to lower the camper.
Unplug the motor 2.
I lifted my camper off the truck and was in the process of lowering it.
All up press and hold button 6 and all 4 jacks extend to raise the camper.
Be careful not to get camper very far out of level.
Unplug the motor 2.
Generally no more than 4 6 inches.
How can we help you.
Re apply brake at desired bed height.
To manually raise the beds.
Looking for some help advice regarding my happijac electric bed and it s wiring configuration.
Happijac s power bed lift supports up to two queen size beds in an innovative patented double bunk bed configuration.
Because the weight of the camper is not the same at all four corners the jacks will not raise and lower at the same speed.
We are committed to providing you with quality customer service so you get the most out of your happijac products.
Emergency manual operation to manually lower the beds.
Happijac s power lift can accommodate one reversible sofa or a sofa single bunk.
Beds can be raised out of the way to make room for atvs or other equipment and lowered again when needed.
Fj60kai on 03 16 12 11 53am hello folks new member here.
It just quit on me so i figured i had blown a fuse.
Bed will slowly drift downward.
All fuses checked out ok.
I m trouble shooting an up raising problem with the beds currently and need to locate the circuit board for the system.
Remove the motor plug from the pnp control module release the brake lever on the end of the motor if beds are up they will drift downward.
My problem seems to be with the remote.
So i looked at the instructions and it mentioned a reset by pushing the acc in and out buttons at the same.
Position the bed s well out of the upper lower limit switches if possible.
