Hanging Crown Molding On Plaster Walls

One of the previous owners had tried to put up crown molding but the job was unfinished and looked bad so i pulled it down.

Hanging crown molding on plaster walls.

The furring strips add more stability to the larger heavier crown molding and greatly simplify nailing the molding to the wall. After all it is just a piece of wood molding. As with all trim secured to old plaster walls locate the studs. If you think something is too heavy then it s best to mount it in a more secure way to the wall.

Use a level or laser level to extend this mark along the walls from corner to corner image 2. Position the molding in the desired location on the wall. I can still give you some great ideas for hanging on plaster walls. The number one trick to cutting inside and outside corner crown molding is to cut each piece upside down with the ceiling side on the bottom and the wall side on the top image 1.

This type of molding was once an elegant way of hanging artwork on hard to penetrate plaster walls. Before installing crown molding test fit a piece of molding in place image 1 and mark the height of the molding where it meets the wall below the ceiling. Well obviously that was just a misfire so we upped the pressure in the tank and fired a few more. Hanging without picture rail.

Cut the first piece square. The nail came out of the gun into the crown molding and then did a 180 against the plaster walls and came back. Install baseboard along the floor at the base of the walls. The second trick is to set the molding against the saw and mark a line on the table with a pencil image 2.

Make a marking gauge the same size as the crown then use it to position the crown on the rail. There were lots of holes chips and cracks in the plaster where they had nailed the molding in the plaster. Popular in new england and southern townhouses during the victorian era picture rails may seem. I repaired the plaster and have painted the walls and now want to put new crown molding up.