Turn the ignition back to run and press the lock button again from the same remote.
H3 door locks not working.
Posted by puddinbb on dec 23 2010.
I noticed when this happened the hummer would be sluggish at starting like the battery did not have a full charge.
If you press the lock button you can hear a clicking noise from the wire harness but nothing happens.
Since the rest of the controls are working then a bad motor in the drivers door becomes very likely.
Check to see if they areagetiing power or not.
All can do that.
The only part that these two have in common is the master switch.
This happened just after i disconnected and re connected the battery.
I m thinking that it might be the relay but i m not sure.
The most likely cause of your problem is the master switch in the drivers door.
The windows and the locks are on two separate circuits.
Ones the locks cycle keep the.
Same thing happened to me.
2010 hummer h3 rear right passenger side door lock latch actuator oem.
Repeat untill all the locks cycle.
Does anyone know where i can get another one to test this theory.
Then hit the lock button on one of the fobs.
The relay that is on there has a ref 02334 and is a 6 pin.
Free shipping on many items.
2007 hummer h3 driverside window will not roll up or down as well as no unlock or lock.
To program a key fob get in vehicle and close all doors.
A few days later it would happen.
I would put the battery charger on overnight and the next day the locks would work.
2005 2010 hummer h3.
2006 hummer h3 driver side window is not working and all door locks are not working either.
Turn the ignition switch to on all dash lights light up on click before starting the car.
There are relays for the windows in the door and check the grounds battery engine and body.
When i try lock the doors i hear a clicking sound but the doors do not lock.
The door locks on my 93 do not work.
Hummer h3 front right rh door lock latch actuator oem 2006 2010 fits.
Insert key into ignition have all the key fobs you want to program for this vehicle in hand programing erases all old fobs.
Of course it is also possible that the wiring harness between the driver side door and cowl is.
Turn the ignition to lock.
The door will need to come apart to test for the power and ground signals to operate the motor from the door module and if they are present then its the motor if not then it is likely the module.
Drivers door would not lock no windows and keyless lock would not engage the locks.
Checked fuses and ran through wires and traced them back to door jam.
