Select the roof fascia leading edge which will be the point that your gutter hosts to.
Gutter wont stay on fascia board revit.
What happened is i d demolished the roof before i attempted to remove the fascia segments.
Since my phase filter was set to previous and new the roof was no longer visible and could not be selected.
Leave the old spikes in place a spike head looks better than a hole in the gutter.
Usually a numeric value.
It s a bummer revit doesn t let you demo selected parts of a fascia or a soffit.
Revit issues a warning if the number is already used but allows you to continue using it.
Your gutters sit right next to them.
You can use the blue arrows to flips the gutter orientation if necessary.
To no avail but i did find that i can assign a fascia to these edges so i have created a fascia profile which is the.
To create gutter down pipes in revit go to the systems tab pipe.
One way to make sure your gutter doesn t fall off the house is to install fascia hanger brackets.
To create gutters in revit go to the architecture tab roof dropdown gutter.
Your gutters could be working well but if your fascia boards are rotten that s a problem.
Remove the gutter brackets from your fascia so you can reuse them on the new board.
Now if you re choosing a fascia sweep as the edge to host your gutters and the fascias don t exactly trim together at a corner then the gutter won t either and you ll have to manually pull the ends of the gutter together to miter the corners.
Highlight horizontal edges of roofs soffits fascias or model lines and click to place the gutter.
A label applied to roof fascia or gutters.
Comments about the roof fascia or gutter.
Then locate the brackets underneath your gutter holding them in place and unscrew them so you can lift the gutter up and away from the fascia.
The fascia is attached to the end of the roof and supports the lower edge of the bottom row of roof tiles.
Your fascia boards are the long boards the run just under the roof.
Check the blue handles at the ends of the gutters and make sure they re both at the same location for each gutter piece.
I have been modelling some roofs with gutters and have come across the limitation of not being able to assign a gutter to an edge that isnt perpendicular to a roof fall i have tried modelling the roof a number of ways by defining the slope at the edge using a slop arrow etc.
Watch the status bar for information about valid references.
Use the gutter tool to add gutters to roofs soffits model lines and fascia.
This value must be unique for each roof fascia or gutter in a project.
The actual length of the fascia or gutter.
Click architecture tab build panel roof drop down roof.
